DONGGUAN MYEKOO INDUSTRIAL EQUIPMENT CO. , LTD.

Home > News > Content
How To Use The Cup Heat Press Machine
- Oct 27, 2018 -

The cup heat press machine can bake any color mark, portrait photo, landscape pattern, etc. on the porcelain cup, and is especially suitable for use as an advertisement, a gift, a publicity event, and the like. At the same time, it can also be used as a personalized item, as well as artistic appreciation and practicality.

1. Wrap the porcelain cup in the picture, put it into the cup heat press mat, adjust the ejector screw to make the pressure moderate, then close the pressure handle, plug in the power, turn on the main power switch (red), the indicator light is on;

Note: The pressure should not be too large, otherwise it will cause the pressure handle to deform! When the picture is over the wall of the cup, the size of the cup should be cut to the same size as the cup wall, and it should be covered on the wall of the cup and glued with the strip. If the image itself is small enough to cover the entire wall, then An additional layer of paper should be placed on the outside to avoid direct contact between the cup wall and the baking mat to prevent the surface of the porcelain cup from being scorched or indented.

2. The cup heat press machine starts to heat up according to the preset temperature. When the set maximum temperature (300-310 degrees Fahrenheit) is reached, the heating is stopped and the timer starts to count;

3. The time reaches the set value (30 seconds), and the buzzer alarms;

4. Turn off the power (red), take out the baked porcelain cup, soak it in clean water for several times (must immerse in cold water to prevent the ink from spreading), take it out, and dry it.

Note: The parameters set above are the setting parameters for the first cup. If the cup heat press is continuous, because the baking mat has residual temperature and is baked according to the above parameters, the image is not so clear, so the temperature and time should be increased accordingly. The specific increase is to adjust the parameters according to experience.