DONGGUAN MYEKOO INDUSTRIAL EQUIPMENT CO. , LTD.

Home > News > Content
Manual Heat Press Machine Operation And Maintenance
- Oct 22, 2018 -

Operational

1. Connect the 220V plug, turn on the main power switch, and the power indicator light is on; (Note that the whole machine must have a solid protective ground wire);

2. Adjust the thermostat to the required temperature (usually 180-200 ° C);

3. Adjust the timer to the required time (usually around 40-45 seconds);

4, put the clothes flat on the silica gel board, and then stack the heat transfer paper (the heat transfer paper has a pattern facing the part of the clothes to be transferred), press the handle firmly until it is completely closed; (Note that the pressure should not exceed 30Kg, otherwise it may cause the handle to be deformed);

5. When the time indicating the hot stamping is over, the buzzer sounds and the handle is returned to the original position;

6. If it is a cold-tipped heat transfer paper, please wipe the eraser paper evenly with a blackboard eraser, wait 5-10 seconds before tearing off the heat transfer paper;

7. If it is hot torn heat transfer paper, you need to tear off the heat transfer paper immediately after hot stamping.

Successful hot stamping requires the right time, temperature and pressure to match each other. The thickness and material of the garment and the type of hot stamping paper all affect the hot stamping effect. All kinds of hot stamping papers need to be tested and sampled before they can be mass-produced .

Maintenance

1. Pressure: If the pressure is not enough or too large, adjust the pressure screw (located at the bottom of the aluminum plate), increase the pressure in the clockwise direction, and reduce the pressure in the counterclockwise direction.

2. Time: When the hot stamping time arrives and the buzzer does not ring or keep sounding, check whether the micro switch contact point in the tail box is moderate. If it is not suitable, adjust it to the appropriate position.

3. Temperature: Preheat for about 15 minutes. When the temperature reaches the set temperature, the heating indicator will be off, and hot stamping can be started. If the heating plate does not heat up for several minutes, please check the line .

heat press machine-224no

heat press machine-206no